Installing Additional Memory; Introduction; Tools Required - HP D5970A - NetServer - LCII User Manual

4 Installing Additional Memory

Introduction

The HP Netserver LP 2000r's main memory is implemented using four memory
slots on the system board which support up to 4 GB (1 GB x 4) of memory. The
Netserver uses only 3.3V, 168-pin, 133 MHz SDRAM DIMMs and ships with at
least one 256 MB DIMM. The embedded video controller is provided with 4 MB
standard video memory and cannot be upgraded.
NOTE
To ensure you have the correct DIMMs before installation, refer to one of the
following for a list of qualified DIMMs:
• HP Order Assistant on the HP web site at:
http://www.hp.com/netserver
• HP Customer Service

Tools Required

The following tools are required to install DIMMs in the HP Netserver.
• An anti-static service kit (3M 8501/8502/8503 or equivalent). This kit
includes a static-dissipating work surface, a chassis clip lead, and a wrist
strap.
Use only PC 133 (133 MHz) SDRAM DIMMs acquired from
Hewlett-Packard. The EDO DIMMs and PC 100 SDRAM
DIMMs from earlier HP Netserver models will fit into the
DIMM slots in the Netserver, but the EDO DIMMs and PC
100 SDRAM will not function properly.
31