Connecting The Uninterruptible Power Supply - HP D5970A - NetServer - LCII User Manual

Chapter 9
2. If you are not replacing the power supply module, insert the power supply
filler panel into the empty power supply bay:
a. Pinch the release lever on the filler panel and pull the lever down.
b. Slide the filler panel into the power bay. See Figure 9-7.
c. Press the release lever in until it clicks into place.
Figure 9-7. Inserting the Power Supply Filler Panel

Connecting the Uninterruptible Power Supply

1. If you have an Uninterruptible Power Supply (UPS) installed in the rack,
turn it on.
2. Connect the serial cable between the UPS and the HP Netserver.
Refer to the user guide included with the UPS for additional information.
The HP Netserver LP 2000r performs a diagnostic test when the power
switch is turned on. If an error condition occurs, refer to Chapter 12,
"Troubleshooting."
92
Connecting the Monitor, Keyboard, Mouse, and UPS