Rear Panel - HP D5970A - NetServer - LCII User Manual

Chapter 1

Rear Panel

The ports and connectors at the rear are listed below and shown in Figure 1-3.
• The power connector accepts a standard power cable to connect the
HP Netserver LP 2000r with a UPS or the site power source. A second power
supply for redundancy is optional. Each power supply has its own power
cord connection.
• The mouse port accepts a standard mouse with a PS/2 connector.
• The keyboard port accepts a standard keyboard with a PS/2 connector.
• The USB (2) ports are provided for devices other than the keyboard or
mouse.
• The Parallel Port is a standard parallel port, which supports Extended
Capabilities Port (ECP)/Enhanced Parallel Port (EPP).
• The Serial/Management Port is a standard serial port, which can be used for a
serial devices or management functions. For more information about
management functions, refer to the Server Management Reference Guide.
• The dedicated serial port is a standard serial port.
• The Video Port interface specifications are listed in Table A-4, "HP
Netserver Hardware Specifications" and Table A-5, "Video Display Modes"
of Appendix A, "Specifications."
• The two LAN ports (LAN A and LAN B) are for the embedded controllers
based on Intel's 82559 10/100 BaseT Fast Ethernet controller. Only LAN A
can be used for the LAN A Power On/Off remote management function.
Each LAN port has a RJ-45 LAN connector and two LEDs to indicate LAN
speed and valid connection or activity. Table 1-3 describes LAN LED
indicators. Refer to Chapter 10, "Configuring the HP Netserver," to change
configuration settings.
• The external SCSI port provides access to external SCSI devices, typically an
external SCSI tape backup device.
4
Controls, Ports and Indicators