Replacing The Front Bezel; Removing The Top Cover - HP D5970A - NetServer - LCII User Manual

Chapter 2
Figure 2-1. Removing the Front Bezel

Replacing the Front Bezel

1. Hook the bottom edge of the bezel onto the pins at the front of the chassis.
See Figure 2-1.
2. Close the bezel and press the top corners to snap it into place.

Removing the Top Cover

You do not need to remove the front bezel to remove the top cover of the
Netserver.
1. If the HP Netserver is operating, log off all users and shut down the operating
system.
2. Pull out the anti-tip foot at the bottom of the rack. Then slowly slide the HP
Netserver chassis out from the rack.
3. Disconnect the power cord and unplug cables.
10
Opening and Closing the HP Netserver