Attaching The Front Bezel; Cabling Rack Components - HP D5970A - NetServer - LCII User Manual

Chapter 8

Attaching the Front Bezel

The bezel attaches to the brackets on the front of the HP Netserver.
1. Hook the bottom edge of the bezel onto the pins on the brackets.
See Figure 8-8 (figure shows flush-mount brackets).
2. Close the bezel and press the top corners to snap it into place.
Pin
Figure 8-8. Attaching the Front Bezel

Cabling Rack Components

After installing the HP Netserver in the rack, refer to the white paper entitled
HP Netserver High Density Rack Solutions Overview (LP 1000r and LP 2000r)
to cable the Netserver in the rack enclosure. The white paper is available on HP's
web site at the following URL:
http://www.hp.com/netserver/support
Rack Mounting the HP Netserver (2-Post)
B
Pin
A
85