HP D5970A - NetServer - LCII User Manual page 31
Hp netserver lp 2000r (1.13, 1.26 & 1.40 ghz) user guide
Hide thumbs
Also See for D5970A - NetServer - LCII:
- Installation manual (203 pages) ,
- Installation and configuration manual (177 pages) ,
- Installation and user manual (174 pages)
Table of Contents
Advertisement
Chapter 3
Figure 3-5. Opening Drive Ejector Arms
2. Remove the drive:
a. Using both hands, grasp the ejector arms and firmly pull the drive out
about an inch to disengage the connection on the backplane.
See Figure 3-6.
b. Wait about 30 seconds for the drive to stop spinning and for the drive
heads to park.
c. Use your hand to support the bottom of the drive, while you slowly pull
the drive straight out. Do not allow the drive to fall.
3. Place the drive in an electrostatic protected container. Do not stack drives.
Installing Mass Storage Devices
25
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the D5970A - NetServer - LCII and is the answer not in the manual?
Questions and answers