System Board - HP ProDesk 600 G4 SFF Maintenance And Service Manual

System board

NOTE: The system board spare park kit includes replacement thermal material.
Follow these steps to remove the system board:
1. Prepare the computer for disassembly (see
2. Remove the access panel (see
a. Front bezel (see
b. WLAN module (see
c. Solid-state drive (see
d. Drive cage (see
e. Shroud (see
f. Fan-sink (see
NOTE:
connector board (see
installed on the replacement system board.
3. Disconnect the following cables from the system board:
(1) Speaker cable
(2) Power supply P1 cable
(3) Power supply P2 cable
(4) Serial connector module cable
Access panel on page
Front bezel on page
{Xref Error! Target does not exist.}
{Xref Error! Target does not exist.}
Drive cage on page
Fan shroud on page
Fan-sink on page
When replacing the system board, be sure that the processor (see
Connector board on page
Preparation for disassembly on page
29), and then remove the following components:
31)
)
)
34)
38)
39)
46) are removed from the defective system board and
28).
Processor on page 40) and
System board 43