Troubleshooting Example Using Cli; System Board Diagnostic Leds; Stby, F/W, And Bmc Leds Locations - HP Rx2620-2 - Integrity - 0 MB RAM Service Manual

00E0 7 CPU0
00F0 7 CPU0

Troubleshooting Example Using CLI

This example uses the CLI and the SEL to display error message indicating that fan 2 (memory
fan) has failed.
cli>sl e
# Sev Generator/Sensor Description
---- - ---------------- ------------ ----------- --------------------------
0010 - BMC
0020 - BMC
0030 - Fan 1 (PSU)
0040 - Fan 3 (CPU)
0050 - ACPI State
0060 - SFW
0070 2 CPU1
0080 2 CPU1
0090 - BMC
00A0 - SEL Time Set
00B0 - Fan 2 (Mem)
00C0 - BMC
00D0 - ACPI State

System Board Diagnostic LEDs

There are three additional LEDs that can help when troubleshooting the server. These LEDs are
located on the system board close to the back of the server and can be viewed through the small
cooling holes in the server case. See
Figure 5-3 STBY, F/W, and BMC LEDs Locations
Table 5-22 details the LED states of the STBY, F/W, and BMC LEDs on the system board.
Halt boot 00037
Halt boot 00037
Event ID
Chass cntrl 00-12:70:A3 81:03
LPC reset 00-12:70:02
OK 11-0A:07:00
OK 13-0A:07:00
S0 (on) FA-22:6F:00
Boot start 00-1D:0A:00
Boot start 00063
Boot start 00063
LPC reset 00-12:70:02
Set FD-C0:03:01
Fail (crit) 12-0A:07:02
Chass cntrl 00-12:70:A3 00:E2
S5 (off) FA-22:6F:05
Figure 5-3 for the STBY, F/W, and BMC LED locations.
DT 04 000000000000000F
Time 2003-10-31 22:29:06
Data, Timestamp
2003-10-31 22:39:02
2003-10-31 22:39:03
2003-10-31 22:39:04
2003-10-31 22:39:04
2003-10-31 22:39:05
2003-10-31 22:39:05
DT 04 0000000000000000
Time 2003-10-31 22:39:05
2003-10-31 22:39:07
2003-10-31 22:39:15
2003-10-31 22:39:24
2003-10-31 22:39:31
2003-10-31 22:39:32
System Board Diagnostic LEDs 109