Operation; Sysmode; Syntax; Parameters - HP Rx2620-2 - Integrity - 0 MB RAM Service Manual

Operation

With no options specified, the command displays the PDT information for the server. The PDT
is cleared and a reboot is required for memory reallocation and safe booting.
Example C-21 pdt Command
Shell> pdt
PDT Information for PD
Last Clear time for PD:
Number of total entries in PD PDT:
Number of used entries in PD PDT:
Number of free entries in PD PDT:
Number of permanent correctable (SBE) entries in PD PDT:
Number of permanent uncorrectable (MBE) entries in PD PDT:
Address of first uncorrectable error in PD:
Example C-22 pdt clear Command
Shell> pdt clear
Are you sure you want to clear the PDT? [y/N] y
Shell>
Shell> pdt
PDT Information
Number of total entries in PDT:
Number of used entries in PDT:
Number of free entries in PDT:
Number of single-bit entries in PDT:
Number of multi-bit entries in PDT:
Address of first multi-bit error: 0x0000000000000000

sysmode

Displays or modifies the system mode.

Syntax

sysmode <normal | admin| service>

Parameters

<normal>
<admin>
<service>
Operation
If specified alone, sysmode displays the system mode. If a mode is specified as a parameter, the
system mode changes immediately. The system mode is retained on successive boots.
PDT has not been cleared
Last Clear time: 10/21/01
sets system mode to normal
sets system mode to admin
sets system mode to service
100
0
50
0x0000000000000000
5:00p
50
0
50
0
0
EFI/POSSE Commands
0
0
161