Removing A Processor; Removing The Processor Airflow Guide - HP Rx2620-2 - Integrity - 0 MB RAM Service Manual

Removing a Processor

To remove a processor module:
1. Power off the server and disconnect all cables. See
2. Remove the top metal cover. See
3. Remove the processor airflow guide. See
a. Remove the IDE cable and power module cables from the processor airflow guide cable
clips.
CAUTION:
to their correct routes.
b. Hold the guide using the opening on top of the guide.
c. At the same time, grasp the back end of the airflow guide and lift the guide out of the
server.
Figure 4-27 Removing the Processor Airflow Guide
4. Disconnect the processor power cable from the server power cable.
5. Disconnect the turbo fan power cable from the system board.
6. Unscrew the two heat sink captive screws, and the four processor captive screws. See
Figure 4-28.
"Removing and Replacing the Top Metal Cover" (page
Record the cable routing of these cables to ensure the cables are returned
"Powering Off the Server" (page
Figure 4-27.
Removing and Replacing Internal Components
37).
43).
63