Sliding The System Board Into The Chassis; Aligning The System Board Pci Connector - HP Rx2620-2 - Integrity - 0 MB RAM Service Manual

2. Grasp the new system board by its edges and carefully align it in the server:
a. Angle the board to allow the PCI connector to slide into the PCI cage bay area. See
Figure
Figure 4-53 Sliding the System Board into the Chassis
b. Align the system board keyholes with their standoffs on the chassis.
c. Slide the PCI connector posts on the system board into their slots on the server chassis.
NOTE:
See
3. Slide the system board toward the rear of the server to secure the system board on its
standoffs. See
Figure 4-54 Aligning the System Board PCI Connector
84 Removing and Replacing Components
4-53.
You must remove the PCI cage from the chassis to install the system board.
"Removing and Replacing PCI Card Cage""Removing the PCI Card Cage" (page
Figure 4-54 and Figure 4-55.
71).