Removing And Replacing Hot-Swap And Hot-Plug Devices; Removing And Replacing Server Fans; Removing A Server Fan; Replacing The Front Bezel - HP Rx2620-2 - Integrity - 0 MB RAM Service Manual

2. Swing the bezel and push toward the front of the server until the bezel locks into place.
Figure 4-8 Replacing the Front Bezel

Removing and Replacing Hot-Swap and Hot-Plug Devices

The server has hard drives that are hot-pluggable and power supplies and fans that are
hot-swappable. This section explains how to replace the following devices while the server is
running:
• System fans
• Power supplies
• Hard drives
There is a significant difference between the terms hot-swap and hot-plug:
• Hot swapping happens at the device level. A hot-swappable device manages insertion or
removal on its own without assistance from operating system commands.
• Hot-plugging allows you to replace a defective component in a high-availability server while
it is running. However, hot-plugging might require interaction with the operating server to
allow the removal and replacement of a hot-plug device.

Removing and Replacing Server Fans

Four server fans keep the server cool. The server fans are hot-swappable, enabling you to replace
a fan while the server is running.
CAUTION:
components from overheating. If the top metal cover is not replaced within 30 minutes, the server
automatically shuts down.
If the server shuts down, replace the top metal cover before you restart the server.

Removing a Server Fan

1. Extend the server from the rack. See
2. Remove the top metal cover. See
46 Removing and Replacing Components
When the server is running, you must replace the top metal cover to prevent
"Extending the Server from the Rack" (page
"Removing the Top Metal Cover" (page
42).
43).