Systems Without An Ilo Management Processor; Diagnostic Leds; Power And System Led States - HP Rx2620-2 - Integrity - 0 MB RAM Service Manual

6. To decode the flashing state of server LED, review the entire SEL and look at events with
alert level 3 and above.
For example:
Log Entry 24: 14 Feb 2003 15:27:02
Alert Level 3: Warning
Keyword: Type-02 1b0800 1771520
Hot Swap Cage: SCSI cable removed
Logged by: BMC;
Data1: Device Removed/Device Absent
0x203E4D0AC6020220 FFFF0008F61B0300
Log Entry 73: 00:00:12
Alert Level 3: Warning
Keyword: Type-02 050301 328449
The server's built-in sensors have detected an open chassis door.
Logged by: BMC;
Data1: State Asserted
0x200000000C020570 FFFF010302050300
NOTE:

Systems Without an iLO Management Processor

The server LED states operate the same as servers that have the optional iLO MP. See
Table 5-3 Power and System LED States
Power LED
Off (flashing green)
On (green)
On (green)
On (green)
On (green)

Diagnostic LEDs

The server has four diagnostic LEDs. These diagnostic LEDs warn of impending or existing
failures and enable you to take preventive or corrective action, such as making a server backup
or replacing a component. These diagnostic LEDs are labeled 1, 2, 3, and 4.
• If no iLO MP is installed, the boot progress is monitored by diagnostic LEDs 1 through 4.
During the boots, the LEDs turn on in sequence until the EFI prompt is reached.
• If an iLO MP is installed, the boot process is monitored by the iLO MP. The diagnostic LEDs
are disabled. For more information, see
Sensor: Cable / Interconnect - SCSI ChExt Cable
Sensor: Physical Security - Chassis Open
More detailed information on the server logs is presented in
System LED
Off
Solid green
Flashing green
Flashing yellow (1/sec.)
Flashing red (2/sec.)
State
Server is off
Running
Booting or running code other than operating system (boot or
diagnostic)
Attention indication
Fault indication
Figure 5-2.
Identifying and Diagnosing Hardware Issues
Appendix C (page 141).
Table 5-3.
103