Figure 4-30 Unlocking the Processor Module Locking Mechanism
9.
Lift the processor up and out of the chassis. Place the processor module into an anti-static
container.
Replacing a Processor
CAUTION:
switches are for factory use. Failure to observe this caution will result in server failure.
1.
Power off the server and disconnect all cables. See
2.
Remove the top metal cover. See
3.
If you are replacing a processor module, remove the old processor as described in
a Processor" (page
4.
Verify the ZIF socket lock is unlocked. The thicker post on the locking mechanism must be
pointed toward the unlock symbol on the ZIF socket.
Do not modify the settings of the DIP switches located on the system board. These
63).
"Powering Off the Server" (page
"Removing and Replacing the Top Metal Cover" (page
Figure 4-33
Removing and Replacing Internal Components
37).
"Removing
shows the socket unlocked.
43).
65