Hot-Plug Disk Drive Indicators; Hot-Plug Disk Drive Led Indicators; Power On/Off Button - HP Rx2620-2 - Integrity - 0 MB RAM Service Manual

Table 2-1 Control Panel LEDs and Switches (continued)
Name
Diagnostic LEDs
1 – 4
Locator Button
and LED
1 See Chapter 5: "Troubleshooting" (page 95)
Table 2-2 Power On/Off Button
Button/Switch
Power Button

Hot-Plug Disk Drive Indicators

The hot-plug disk drives have two LEDs per drive. For the location and description of the hard
drive LEDs, see
Figure 2-3 Hot-Plug Disk Drive LED Indicators
30 Controls, Ports, and LEDs
Function
The four diagnostic LEDs operate in conjunction with the system LED to provide diagnostic
information about the system.
The Locator button and LED are used to help locate this server within a rack of servers. When
the button is engaged, the blue LED illuminates and an additional blue LED on the rear panel of
the server illuminates. This function can be remotely activated.
Description
Controls the power supply (turns system power on or off) if power is available to the power
supply. (Controls both power supplies if two are installed).
If power is off but power is available to the power supplies, pressing the Power button:
• Momentarily (less than 5 seconds) turns on the power supplies and applies power to
server circuits.
• More than 5 seconds, then released, has no effect.
If power is on and the system is at initial system loader, pressing the Power button:
• Momentarily (less than one second) has no effect.
• More than one second, but less than five seconds—do not use. This initiates e-buzzer
functions that are not supported in the server.
• More than five seconds, then released, causes an immediate hard power off.
If power is on and the system is at BCH, pressing the Power button:
• Momentarily (less than one second) causes a immediate and hard power off.
• More than one second, but less than five seconds—do not use. This initiates e-buzzer
functions that are not supported in the server.
• More than five seconds, then released, causes an immediate hard power off.
If power is on but the operating system shuts down, pressing the Power button:
• Momentarily (less than 5 seconds) causes a system power off.
• More than five seconds, then held, causes a system power off.
If the OS is running, pressing the Power button:
• Momentarily (less than 5 seconds) requests a soft power down by the operating system.
The operating system determines if the power off request is to be honored.
• More than five seconds, then released, causes an immediate hard power off without
allowing the operating system to close open files or flush disk caches possibly resulting
in a corrupted disk system or file. This should only be used when the operating system
is not responding to user requests.
Figure 2-3 and Table 2-3.
1
for information provided by the system and diagnostic LEDs.