Configuring Snmp Information - Brocade Communications Systems A7990A - StorageWorks SAN Director 4/16 Blade Switch Administrator's Manual

17

Configuring SNMP Information

When you configure SNMP information for a SilkWorm 24000 or 48000 configured with two logical
switches, it is on a logical-switch basis. This means that for each logical switch, you must configure
SNMP information individually.
To change the systemGroup configuration parameters
1. Launch the Switch Admin module as described on
2. Click the SNMP tab (see
3. Type a contact name, description, and location in the SNMP Information section.
4. Optional: Click the Enable Authentication Trap checkbox to allow authentication traps to be sent
to the reception IP address.
5. Click Apply.
To set SNMPv1 configuration parameters
1. Launch the Switch Admin module as described on
2. Click the SNMP tab (see
3. Double-click a community string in the SNMPv1 section and type a new community string.
4. Double-click a recipient IP address in the SNMPv1 section and type a new IP address.
5. Click Apply.
To set SNMPv3 configuration parameters
1. Launch the Switch Admin module as described on
2. Click the SNMP tab (see
3. Select a user name from the User Name drop-down menu in the SNMPv3 section.
4. Double-click a recipient IP address in the SNMPv3 section and type a new IP address.
5. Select a trap level from the Trap Level drop-down menu.
6. Click Apply.
To change the access control configuration
1. Launch the Switch Admin module as described on
2. Click the SNMP tab (see
3. Double-click an access host IP address in the Access Control List section and type a new host IP
address.
4. Select a permission for the host from the Access Control List drop-down menu. Options are Read
Only and Read Write.
5. Click Apply.
17-14
page
Figure 17-5).
page
Figure 17-5).
page
Figure 17-5).
page
Figure 17-5).
3-3.
3-3.
3-3.
3-3.
Web Tools Administrator's Guide
Publication Number: 53-0000194-01