Adding And Removing Members Of A Quickloop - Brocade Communications Systems A7990A - StorageWorks SAN Director 4/16 Blade Switch Administrator's Manual

The Add Member button becomes active.
6. Click Add Member to add QuickLoop members.
Selected members are moved to the QuickLoop Members area.
7. Optional: Repeat steps 6 and 7 to add a second element to your QuickLoop.
At this point you can either save your changes or save and enable your changes.
8. Click Zoning Actions > Save Config Only to save the configuration changes.
To enable the configuration, see

Adding and Removing Members of a QuickLoop

Use the following procedure to add or remove members of a QuickLoop.
To modify the members of a QuickLoop
1. Launch the Zone Administration module as described on
2. Click the QuickLoop tab.
3. Select the QuickLoop you want to modify from the Name drop-down menu.
4. Select an element in the Member Selection List that you want to include in the QuickLoop, or
select an element in the QuickLoop Members that you want to delete.
5. Click Add Member to add a QuickLoop member or Remove Member to remove a QuickLoop
member.
At this point you can either save your changes or save and enable your changes.
6. Click Zoning Actions > Save Config Only to save the configuration changes.
To enable the configuration, see
Web Tools Administrator's Guide
Publication Number: 53-0000194-01
Note
There is a limit of two members per QuickLoop. Only switches capable of running
QuickLoop are displayed in the Member Selection List.
"Enabling Zone Configurations"
Note
There is a limit of two members per QuickLoop. Only switches capable of running
QuickLoop are displayed in the Member Selection List.
"Enabling Zone Configurations"
on page 9-23.
page 9-3.
on page 9-23.
9
9-15