3
Enabling and Disabling Blades
The procedure in this section applies only to the SilkWorm 24000 and 48000 directors (bladed
switches).
To enable or disable a blade
1.
Launch the Switch Admin module as described on
2.
Click the Blade tab.
The Enable Blade column in the Blade tab pane indicates whether the blade is enabled.
Figure 3-3
3.
Check the Enable Blade checkbox for each blade you want to enable. Uncheck the checkbox to
disable the blade. You cannot enable or disable the CP blades.
4.
Click Apply.
3-6
Blade Tab
page
3-3.
Web Tools Administrator's Guide
Publication Number: 53-0000194-01