Fabric Os Commands For Configuring Snmp; Support For Administrative Domains; Support For Role Based Access Control; Support For Ip V6 Addressing - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Reference Manual

1

Fabric OS Commands for Configuring SNMP

Fabric OS Commands for Configuring SNMP
Use the following commands to configure MIBs in the Fabric OS. Refer to the Fabric OS
Administrator's Guide for procedures for configuring SNMP on the Brocade switches.
TABLE 4
Command
snmpConfig
snmpMibCapSet
snmpMibCapShow
agtcfgDefault
agtcfgSet
agtcfgShow
SNMPMibCapSet
SNMPMibCapShow

Support for Administrative Domains

Administrative Domains are supported in Fabric OS Version 5.3.0 and later releases. An
Administrative Domain (AD) is a domain within a fabric. Administrative domains can be used to limit
administrator access within a fabric, and to provide service providers with a means to assign
portions of a fabric to individual consumers. An AD may contain switches, devices, and ports. An AD
may also limit access to a configured set of users.

Support for Role Based Access Control

Role Based Access Control (RBAC) is supported in Fabric OS Version 5.3.0 and later releases. RBAC
applies a fixed set of roles that address the access control needs of a majority of customers. Each
role is a set of permissions that can be applied to a user that controls the kinds of jobs and tasks
the user can perform on a fabric or fabric element.

Support for IP V6 Addressing

IP V6 addressing is supported in Fabric OS Version 5.3.0 and later releases.

Support for Virtual Fabric

Virtual Fabric is supported in Fabric OS Version 6.2.0.
12
Commands for Configuring SNMP
Description
This command has all the features of the existing the agtcfg* commands; in
addition, it has SNMPv3 configuration parameters.
Enhanced in Fabric OS v4.4 to provide a filter facility at the trap level (previously the
filter facility was at MIB level for traps).
Enhanced in Fabric OS 5.3.0 to support enabling and disabling of MIBs and traps
for the FCIP MIB and the ifTable and ifXTable for FC ports (MIB II Intefaces group).
Enhanced in Fabric OS 6.2.0, where FCIP is enabled by default.
Displays the snmpMibCapSet command settings.
This command is deprecated. Only the snmpConfig command is working.
This command is deprecated. Only the snmpConfig command is working.
This command is deprecated. Only the snmpConfig command is working.
This command is deprecated. Only the snmpConfig command is working.
This command is deprecated. Only the snmpConfig command is working.
Fabric OS MIB Reference
53-1001156-01