Download Print this page

Firmware Upgrades And Enabled Traps; Fabric Os Commands For Configuring Snmp - Brocade Communications Systems StoreFabric SN6500B Reference Manual

Brocade fabric os mib reference v7.1.0 (53-1002750-01, march 2013)
Hide thumbs Also See for StoreFabric SN6500B:

Advertisement

1

Firmware upgrades and enabled traps

TABLE 4
MIB name
FE-MIB
CPQ-Rack MIB
FCIP MIB
iSCSI MIB
IF-MIB
BD-MIB
IEEE 802.3 LAG MIB
IEEE 802.1x PAE MIB
LLDP MIB
BRIDGE-MIB
RMON-MIB
FA-Ext
SNMPv2 MIB

Firmware upgrades and enabled traps

The pre-Fabric OS v4.4 firmware had trap group level settings (for example, traps were turned on
and off as a group). In Fabric OS v4.4 or later, you can turn on and off traps individually within a
trap group. When you upgrade to the Fabric OS v4.4 firmware or later, by default the individual
traps are turned off even if the corresponding trap group was enabled before upgrading. You must
use the snmpconfig command to turn on explicitly the individual traps within each trap group.

Fabric OS commands for configuring SNMP

Use the following commands
configuring SNMP on the Brocade switches, refer to the Fabric OS Administrator's Guide.
TABLE 5
Command
snmpConfig
snmpTraps
For more information about the commands, either refer to
Reference.
20
Access Gateway MIB support (Continued)
Supported
No
Limited
No
No
Yes
Yes
No
No
No
No
Yes
Yes
Yes
(Table
5) to configure MIBs in the Fabric OS. For procedures for
Commands for configuring SNMP
Description
This command has all the features of the existing agtcfg* commands; in addition, it has
SNMPv3 configuration parameters.
Enhanced in Fabric OS v6.3.0 to support SNMP Informs for SNMPv3 users.
Enhanced in Fabric OS v6.4.0 to support option-based mibcapability behavior.
This command supports the SNMP notification generator feature, Notification generator
framework has been implemented to send various SNMP traps.
Description
Disabled in Access Gateway because the conventions are specific to
fabric switches.
Supported on embedded switches only.
Disabled in Access Gateway because the conventions are specific to
fabric switches.
Disabled in Access Gateway because the conventions are specific to
fabric switches.
Supported in Access Gateway.
Supported for F-ports.
Supported in Access Gateway.
Supported in Access Gateway.
Supported in Access Gateway.
Supported in Access Gateway.
Supported in Access Gateway.
Supported in Access Gateway.
Supported in Access Gateway.
Table 6
or the Fabric OS Command
Fabric OS MIB Reference
53-1002750-01

Advertisement

loading