Adding And Removing Fabric Assist Zone Members - Brocade Communications Systems A7990A - StorageWorks SAN Director 4/16 Blade Switch Administrator's Manual

9
11. Optional: Click Add Other Host to include a WWN, port, or QuickLoop (AL_PA) that is not
currently a part of the fabric.
The new members appear in the Fabric Assist Members area. The newly created Fabric Assist zone
also displays in the Config tab. At this point you can either save your changes or save and enable
your changes.
12. Click Zoning Actions > Save Config Only to save the configuration changes.
To enable the configuration, see
Adding and Removing Fabric Assist Zone
Members
Use the following procedure to add and remove Fabric Assist zone members.
To modify the members of a Fabric Assist zone
1. Launch the Zone Admin module as described on
2. Click the Fabric Assist tab.
3. Select the Fabric Assist zone you want to modify from the Name drop-down menu.
4. Click an element in the Member Selection List that you want to include in your Fabric Assist zone,
or click an element in the Fabric Assist Zone Members that you want to delete.
5. Click Add Member to add a Fabric Assist zone member.
Click Remove Member to remove a Fabric Assist zone member.
At this point you can either save your changes or save and enable your changes.
6. Click Zoning Actions > Save Config Only to save the configuration changes.
To enable the configuration, see
9-18
"Enabling Zone Configurations"
page 9-3.
"Enabling Zone Configurations"
on page 9-23.
on page 9-23.
Web Tools Administrator's Guide
Publication Number: 53-0000194-01