4
Connecting the router to a network device
Installing a fiber-optic transceiver
To connect a router to another network device using a fiber port, install a fiber-optic transceiver
(SFP, SFP+, or XFP, as required by your interface module).
DANGER
All fiber-optic interfaces use Class 1 Lasers.
NOTE
Refer to
Before installing a fiber-optic transceiver, have on hand an ESD wrist strap with a plug for
connection to the ESD connector on the router chassis.
DANGER
For safety reasons, the ESD wrist strap should contain a 1 megohm series resistor.
Follow these steps to install a fiber-optic transceiver.
1. Put on the ESD wrist strap and ground yourself by inserting the plug into the ESD connector on
2. Remove the transceiver from the protective packaging.
3. Remove the metal cover from the port on the interface module.
4. Gently insert the fiber-optic transceiver into the port until the transceiver clicks into place.
Cabling a fiber-optic transceiver
Follow these steps to cable a fiber-optic transceiver.
1. Remove the protective covering from the fiber-optic port connectors and store the covering for
2. Before cabling a fiber-optic transceiver, it is strongly recommended that you clean the cable
3. Gently insert the two cable connectors (a tab on each connector should face upward) into the
Cleaning fiber-optic ports and connectors
To avoid problems with connections between fiber-optic ports and fiber cable connectors, it is
strongly recommended that you clean ports and connectors each time you make a connection.
Dust can accumulate inside the port and connector and cause problems as serious as reducing the
optic launch power.
When you are not using a fiber-optic transceiver port, always replace the protective cover.
96
"Installation precautions"
the router chassis.
Transceivers are keyed to prevent incorrect insertion.
future use.
connectors and the port connectors. For more information, refer to
and
connectors".
ports until the tabs lock into place.
on page 137 for other hardware installation precautions.
PowerConnect B-MLXe Hardware Installation Guide
"Cleaning fiber-optic ports
53-1002111-01