Table of Contents
Advertisement
2
Installing a PowerConnect B-MLXe-16 router
9. Attach the cable management comb. Refer to
NOTE
The cable managment comb is sold separately.
FIGURE 45
10. Route cables through the cable management comb.
Repeat steps 1 through 9 for each router you install in the cabinet.
Installing modules in a PowerConnect B-MLXe 16-slot router
The installation sequence for multiple modules is important to ensure proper fit. Always fill the
bottom slots in the PowerConnect B-MLXe-16 router first. Begin by filling the slots from the left side
of the router, and work towards the right side. Refer to
NOTE
Installation instructions are identical for interface, management, and switch fabric modules.
However, there are specific switch fabric and fan requirements for NI-MLX-10x8G and
NI-MLX-1Gx48-T-A modules in the 16-slot router. Refer to
B-MLXe 16-slot router"
DANGER
The intra-building ports of the equipment or subassembly are suitable for connection to
intra-building or unexposed wiring or cabling only. The intra-building ports of the equipment or
subassembly MUST NOT be metallically connected to interfaces that connect to the outside plant
(OSP) or its wiring. These ports are designed for use as intra-building interfaces only (Type 2 or
Type 4 ports as described in GR-1089-CORE, Issue 4) and require isolation from the exposed
OSP cabling. The addition of Primary Protectors is not sufficient protection to connect these
interfaces metallically to OSP wiring.
62
Attach the cable management comb
on page 62.
Figure
45.
Figure 3
on page 4 for slot locations.
"Installing modules in a PowerConnect
PowerConnect B-MLXe Hardware Installation Guide
53-1002111-01
Advertisement
Table of Contents
