Dell PowerConnect B - MLXe 4 Hardware Installation Manual page 24

Hardware installation guide
Table of Contents

Advertisement

1
Router modules
24-port 100/1000 Ethernet interface module
Figure 7
FIGURE 7
The front panel includes the following features:
Table 8
TABLE 8
Position
Below each Ethernet port.
(Left-side LED supports port in
top row. Right-side LED supports
port in bottom row.)
100/1000 Ethernet ports
The 100/1000 Ethernet interface module contains 24 physical ports, through which you can
connect your router to other network routers at a speed of 100 Mbps or 1 Gbps.
You must insert an SFP-compliant fiber-optic transceiver (provided by Dell) into a physical port.
SFP-compliant fiber-optic transceivers provide a physical medium-dependent (PMD) fiber interface
that can be used with either the LAN physical layer (PHY) or WAN physical layer (WAN PHY).
12
If you try to configure MPLS on device that has NI MLX 8x10G -D modules installed, you will see
the following error message.
PowerConnect MLX-8 Router(config)# router mpls
The command can't be used when system contains -d class modules.
If you install an NI-MLX-10Gx8-D module in a device that is running MPLS, the NI-MLX-10Gx8-D
module will boot in INTERACTIVE mode, and the following error message is displayed.
R2-MLX#
Module is inserted into slot 7
SYSLOG: May 28 16:22:35:<13>May 28 16:22:35 System: Module was inserted to
slot 7
Module 7 is -d class, it can't work when router mpls is enabled.
Reset slot 7
SYSLOG: May 28 16:22:48 :<13>May 28 16:22:48 Module 7 is reset by mgmt
(reason: boot to interactive mode)
shows the front panel of the 24-port 100/1000 Gbps Ethernet SFP interface module.
24-port 100/1000 Ethernet module front panel
LEDs to the left support the top ports, LEDs to the right support the bottom ports
24 100/1000 Ethernet SFP ports
describes the LEDs for the 24-port 100/1000 Ethernet module
24-port 100/1000 Ethernet module LEDs
State
Meaning
On or blinking
The port is transmitting and receiving packets.
Off for an extended period
The port is not transmitting or receiving packets.
PowerConnect B-MLXe Hardware Installation Guide
53-1002111-01

Advertisement

Table of Contents
loading

This manual is also suitable for:

Powerconnect b - mlxe 8

Table of Contents