Table of Contents
Advertisement
1
Router modules
TABLE 2
Management module LEDs
LED
Position
Port 1
Each adjacent to
and
the PCMCIA slot
Port 2
that it represents
Active
Lower Left
Pwr
Upper Left
10/100/1000
Above and right of
Ethernet Port
RJ45 connector
10/100/1000
Above and left of
Ethernet Port
RJ45 connector
Interface modules
Table 3
TABLE 3
Part Number
DL-MLX-10Gx4-X-ML
DL-MLX-1GFx24-X-ML
DL-MLX-1GCx24-X-ML
DL-NI-MLX-10Gx8-M
DL-NI-MLX-10Gx8-D
Depending on your router model, you can install up to 16 interface modules.
Interface modules are hot-swappable, which means you can remove and replace them without
powering down the system.
10 Gbps Ethernet interface modules (4-port)
Figure 5
8
State
Meaning
On or blinking
The software is currently accessing the PCMCIA flash card.
Off
The software is not currently accessing a PCMCIA flash card, although there is
one inserted in the slot.
On
The module is functioning as the active management module.
Off
The module is functioning as the redundant management module.
On
The module is receiving power.
Off
The module is not receiving power.
On (Green)
A link is established with the remote port.
Off
No link is established with the remote port.
On or blinking
The port is transmitting and receiving packets.
(Yellow)
Off for an
The port is not transmitting or receiving packets.
extended period
lists the interface modules that are available for PowerConnect B-MLXe routers.
Interface modules
Description
4-port 10 Gbps Ethernet module with IPv4, IPv6, and MPLS hardware support--requires
XFP optics
24-port FE or GE (100/1000) module with IPv4, IPv6, and MPLS hardware
support--requires SFP optics
24-port 10/100/1000 copper modules with IPv4, IPv6, and MPLS hardware support
shows 4-port 10 Gbps Ethernet interface module front panels.
PowerConnect B-MLXe Hardware Installation Guide
53-1002111-01
Advertisement
Table of Contents
