Table of Contents
Advertisement
NOTE
Because of the weight of a fully loaded PowerConnect B-MLXe-4 router, Dell recommends mounting
it in a rack before installing the modules and AC power supplies.
You can install up to eight PowerConnect B-MLXe-4 routers in a standard 19-inch (EIA310-D)
two-post rack using the factory-installed mounting brackets for either front- or mid-mounts.
If you use the air duct rack mount method, you can install up to six PowerConnect B-MLXe-4 routers
in a cabinet or four-post rack using the cabinet mounting kit.
Mounting your device in a standard rack
The factory-installed mounting brackets allow you to front-mount or mid-mount your device in the
rack. For a mid-mount, you must remove the factory installed brackets from the front edge of the
device and install them using the holes in the center-sides of the device. Refer to
You will need to provide four standard #12-24 pan-head screws (per router) to secure routers in the
rack. You will also need a #2 Phillips screwdriver. Complete the following steps.
NOTE
When connecting the device to the rack frame, use thread-forming screws and paint-piercing
washers.
1. Determine the position of each router in the rack according to the weight of the router. For
2. Using the keyhole slots in the router mounting brackets as a guide, align one screw per rack
PowerConnect B-MLXe Hardware Installation Guide
53-1002111-01
example, mount the router with the fewest modules near the top of the rack, a router with more
modules near the middle of the rack, and fully populated routers near the bottom of the rack.
post, as shown in
Figure
33. On one side of the rack, the screw should align with the top hole in
the mounting bracket. On the other side of the rack, the screw should align with the bottom
hole of the mounting bracket. When tightening these screws, leave approximately 1/4 inch of
clearance between the back of the screw head and the rack post.
Installing a PowerConnect B-MLXe-4 router
2
Figure
16.
27
Advertisement
Table of Contents
