Dell PowerConnect B - MLXe 4 Hardware Installation Manual page 141

Hardware installation guide
Table of Contents

Advertisement

08/06/2008 03:42:12
07/30/2008 10:21:56
08/09/2008 09:03:14
08/10/2008 12:49:09
08/16/1908 06:38:47
08/15/1908 09:21:34
08/20/1908 12:38:45
08/21/1908 12:12:27
08/27/1908 11:25:18
08/31/1908 06:13:15
08/17/1908 14:10:29
08/27/1908 11:25:48
08/31/1908 06:13:43
08/31/1908 06:53:40
If necessary, you can delete the mbridge.old file to increase the available memory. Though unlikely,
you may have to delete additional files for the upgrade to succeed. Contact Dell technical support
before removing additional files.
PowerConnect# delete___mbridge.old
NOTE
The file name delete___mbridge.old must contain three underscores.
After deleting the mbridge.old file, enter to dir command to verify that the mbridge.old file has been
removed, and that there are enough bytes free to begin the upgrade.
PowerConnect# dir
Directory of /flash/
08/31/1908 13:26:14
08/06/2008 03:42:12
07/30/2008 10:21:56
08/09/2008 09:03:14
08/10/2008 12:49:09
08/16/1908 06:38:47
<<<<<<<<<<<<<<<<<<<<<mbridge.old file is removed
08/20/1908 12:38:45
08/21/1908 12:12:27
08/27/1908 11:25:18
08/31/1908 06:13:15
08/17/1908 14:10:29
08/27/1908 11:25:48
08/31/1908 06:13:43
08/31/1908 06:53:40
You must also delete the mbridge.old file from the redundant management module, if one is
installed. To access the redundant management module, enter the switchover command to make it
the active management module.
PowerConnect B-MLXe Hardware Installation Guide
53-1002111-01
Important software upgrade considerations
980,769 IMF.cfg
981,804 IMF1.cfg
2,663,857 ___mbridge
2,663,857 ___mbridge.old
524,288 lp-monitor-0
3,335,554 lp-primary-0
3,304,730 lp-secondary-0
422,393 monitor
6,530,021 primary
6,244,777 secondary
981,549 startup-config
15 File(s)
28,636,142 bytes
0 Dir(s)
2,097,152 bytes free
<<<<<
980,769 IMF.cfg
981,804 IMF1.cfg
2,663,857 ___mbridge
524,288 lp-monitor-0
3,335,554 lp-primary-0
3,304,730 lp-secondary-0
422,393 monitor
6,530,021 primary
6,244,777 secondary
981,549 startup-config
14 File(s)
25,972,285 bytes
0 Dir(s)
4,718,592 bytes free
705 $$sshdsspub.key
1,712 $$sslcert.key
123 boot-parameter
3 $$snmp_boots
705 $$sshdsspub.key
1,712 $$sslcert.key
123 boot-parameter
6
<<<<<<<<<<<<<
129

Advertisement

Table of Contents
loading

This manual is also suitable for:

Powerconnect b - mlxe 8

Table of Contents