Table of Contents
Advertisement
Error
code
1
2
3
4
5
6
7
8
16
17
18
19
20
21
22
23
PowerConnect B-MLXe Hardware Installation Guide
53-1002111-01
Diagnostic error codes and remedies for TFTP transfers
Message
Flash read preparation failed.
Flash read failed.
Flash write preparation failed.
Flash write failed.
TFTP session timeout.
TFTP out of buffer space.
TFTP busy, only one TFTP session
can be active.
File type check failed.
TFTP remote - general error.
TFTP remote - no such file.
TFTP remote - access violation.
TFTP remote - disk full.
TFTP remote - illegal operation.
TFTP remote - unknown transfer
ID.
TFTP remote - file already exists.
TFTP remote - no such user.
Explanation and action
A flash error occurred during the download.
Retry the download. If it fails again, contact customer support
TFTP failed because of a time out.
Check IP connectivity and make sure the TFTP server is running.
The file is larger than the amount of space on the device or TFTP
server.
If you are copying an image file to flash, first copy the other image
to your TFTP server, then delete it from flash. (Use the erase flash...
CLI command at the Privileged EXEC level to erase the image in the
flash.)
If you are copying a configuration file to flash, edit the file to
remove unneeded information, then try again.
Another TFTP transfer is active on another CLI session, SNMP, or
Web management session. Retry the transfer after a period of time.
You accidentally attempted to copy the incorrect image code into
the system.Retry the transfer using the correct image.
There is an error in the TFTP configuration. The error message
describes the error. Correct the error, then retry the transfer.
6
159
Advertisement
Table of Contents
