Configuring Dvmrp - Dell PowerConnect 7048P Manual

Configuring DVMRP

The following example configures two DVMRP interfaces on the switch to
enable inter-VLAN multicast routing.
To configure the switch:
1 Globally enable IP routing and IP multicast.
console#configure
console(config)#ip routing
console(config)#ip multicast
2 Globally enable IGMP so that this L3 switch can manage group
membership information for its directly-connected hosts. Enabling IGMP
is not required if there are no directly-connected hosts.
console(config)#ip igmp
3 Globally enable DVMRP.
console(config)#ip dvmrp
4 Enable DVMRP and IGMP on VLAN routing interfaces 10 and 20.
console(config)#interface vlan 10
console(config-if-vlan10)#ip address 192.168.10.1
255.255.255.0
console(config-if-vlan10)#ip dvmrp
console(config-if-vlan10)#ip igmp
console(config-if-vlan10)#exit
console(config)#interface vlan 20
console(config-if-vlan20)#ip address 192.168.20.1
255.255.255.0
console(config-if-vlan20)#ip dvmrp
console(config-if-vlan20)#ip igmp
console(config-if-vlan20)#exit
Managing IPv4 and IPv6 Multicast
1215