Dell PowerConnect 7048P Manual page 1208

Command
ipv6 pimsm bsr-candidate
vlan-id hash-mask-
vlan
length priority
[
ipv6 pim rp-candidate vlan
vlan-id group-address/prefix-
length
ipv6 pim rp-address
address group-address/prefix-
length
[override]
ipv6 pim ssm {default |
group-address/prefix-length
vlan-id
interface vlan
1208
Managing IPv4 and IPv6 Multicast
Purpose
Configure the switch to announce its candidacy as a
bootstrap router (BSR)
]
•
•
•
Configure the router to advertise itself as a PIM
candidate rendezvous point (RP) to the bootstrap
router (BSR).
•
•
rp-
(Optional) Statically configure the RP address for one
or more multicast groups. Only one RP address can be
used at a time within a PIM domain
The optional keyword override indicates that if there
is a conflict, the RP configured with this command
prevails over the RP learned by BSR.
Define the Source Specific Multicast (SSM) range of
} IPv6 multicast addresses.
• default — Defines the SSM range access list to
•
Enter Interface Configuration mode for the specified
VLAN.
vlan-id
— A valid VLAN ID.
hash-mask-length
— The length of a mask that is to
be ANDed with the group address before the hash
function is called. All groups with the same seed
hash correspond to the same RP . For example, if this
value is 24, only the first 24 bits of the group
addresses matter. This allows you to get one RP for
multiple groups. (Range 0–32 bits).
priority
— The priority of the candidate BSR. The
BSR with the higher priority is preferred. If the
priority values are the same, the router with the
higher IPv6 address is the BSR. (Range 0–255).
vlan-id
— A valid VLAN ID.
group-address/prefix-length
and prefix length supported by RP .
FF3x::/32.
group-address/prefix-length
range.
— Group IPv6 address
— defines the SSM