Configuring Copp For Ospfv3 - Dell S4048T Configuration Manual

CPU Queue Weights
11 32
Catch-All Entry for IPv6 Packets
Dell Networking OS currently supports configuration of IPv6 subnets greater than /64 mask length, but the
agent writes it to the default LPM table where the key length is 64 bits. The device supports table to store up
to 256 subnets of maximum of /128 mask lengths. This can be enabled and agent can be modified to update
the /128 table for mask lengths greater than /64. This will restrict the subnet sizes to required optimal level
which would avoid these NDP attacks. The IPv6 stack already supports handling of >/64 subnets and doesn't
require any additional work. The default catch-all entry is put in the LPM table for IPv4 and IPv6. If this is
included for IPv6, you can disable this capability by using the no ipv6 unknown-unicast command.
Typically, the catch-all entry in LPM table is used for soft forwarding and generating ICMP unreachable
messages to the source. If this is in place then irrespective of whether it is </64 subnet or >/64 subnet, it
doesn't have any effect as there would always be LPM hit and traffic are sent to CPU.
Unknown unicast L3 packets are terminated to the CPU CoS queue which is also shared for other types of
control-plane packets like ARP Request, Multicast traffic, L3 packets with Broadcast MAC address. The catch-
all route poses a risk of overloading the CPU with unknown unicast packets. This CLI knob to turn off the
catch-all route is of use in networks where the user does not want to generate Destination Unreachable
messages and have the CPU queue's bandwidth available for higher priority control-plane traffic.

Configuring CoPP for OSPFv3

You can create an IPv6 ACL for control-plane traffic policing for OSPFv3, in addition to the CoPP support for
VRRPv3, BGPv6, and ICMPv6. You can use the ipv6 access-list name cpu-qos permit ospfv3 or the
ipv6 access-list name cpu-qos ospfv3 command to allow CoPP traffic for OSPFv3. The control
plane management support for IPv6 ICMPv6 packets is enhanced to enable more number of CPU queues on
port to be available and other COPP improvements have been implemented.
To configure control-plane policing, perform the following:
1 Create an IPv6 ACL for control-plane traffic policing for ospfv3.
CONFIGURATION mode
Dell(conf)#ipv6 access-list ospfv3 cpu-qos
Dell(conf-ipv6-acl-cpuqos)#permit ospf
2 Create a QoS input policy for the router and assign the policing.
CONFIGURATION mode
Dell(conf)#qos-policy-input ospfv3_rate cpu-qos
Dell(conf-in-qos-policy-cpuqos)#rate-police 1500 16 peak 1500 16
3 Create a QoS class map to differentiate the control-plane traffic and assign to the ACL.
CONFIGURATION mode
Dell(conf)#class-map match-any ospfv3 cpu-qos
Rate (pps)
300
Protocol
PIM, IGMP, MSDP, MLD
Control Plane Policing (CoPP) 290