Radius-Server Deadtime - Cisco Nexus 5500 Series Command Reference Manual

radius-server deadtime

radius-server deadtime
To configure the dead-time interval for all RADIUS servers on a Cisco Nexus 5000 Series switch, use
the radius-server deadtime command. To revert to the default, use the no form of this command.
Syntax Description
minutes
Command Default
0 minutes
Command Modes Global configuration mode
Command History Release
5.2(1)N1(1)
Usage Guidelines The dead-time interval is the number of minutes before the switch checks a RADIUS server that was
previously unresponsive.
When the idle time interval is 0 minutes, periodic RADIUS server monitoring is not performed.
Note
Examples
This example shows how to configure the global dead-time interval for all RADIUS servers to perform
periodic monitoring:
switch(config)# radius-server deadtime 5
This example shows how to revert to the default for the global dead-time interval for all RADIUS servers
and disable periodic server monitoring:
switch(config)# no radius-server deadtime 5
Related Commands Command
show radius-server
Cisco Nexus 5500 Series NX-OS Security Command Reference
220
radius-server deadtime minutes
no radius-server deadtime minutes
Number of minutes for the dead-time interval. The range is from 1 to 1440
minutes.
Modification
This command was introduced.
Description
Displays RADIUS server information.
Chapter R Commands
OL-27883-02