72
|
Maintaining the Printer
Note: You can change the
units of measurement
from centimeters to
inches and feet using
maintenance mode on
the printer's control
panel. See page 120 for
instructions.
3. Do one of the following:
To check the firmware version, press
•
press the l button.
To check the number of pages that can be printed with each ink
•
cartridge, press d to highlight
. Press d to view the number of pages remaining for each
Menu
cartridge. When done, press l.
(This option must be enabled using maintenance mode on the
printer's control panel to display information. See page 120 for
instructions.)
To check the amount of ink left, press d to highlight
•
then press
Menu
Continue pressing d to see the status of the remaining cartridges.
When done, press l.
To check the total amount of ink used (in milliliters) and media
•
used, press d to highlight
When done, press l.
You can clear this setting with the
To check the job history, press d to highlight
•
press
. For the last 10 print jobs saved in the printer, you see
Menu
the ink used (in milliliters) and media used (in square centimeters).
The most recent job is saved as No. 0. When done, press l.
To check the total number of prints, press d to highlight
•
, then press
PRINTS
To check the status of the EDM feature and when it was last
•
uploaded, press d to highlight
(See www.myepsonprinter.com for more information.) When done,
press l.
4. Press the Pause button to exit the menu.
PRINTABLE PAGES
. The status of the first cartridge is displayed.
USAGE COUNT
CLEAR USAGE COUNT
. When done, press l.
Menu
EDM STATUS
72
again. When done,
Menu
, then press
INK LEVEL
, then press
Menu
JOB HISTORY
TOTAL
, then press
Menu
,
.
option.
, then
.