Epson Stylus Pro GS6000 Setup and Setup And Use Manual page 103

Message
PAPER ERROR
LOAD PAPER PROPERLY
PAPER JAM
REMOVE PAPER
PAPER OUT
LOAD PAPER
PAPER SKEW
LOAD PAPER PROPERLY
PRINTER ERROR
RESTART THE PRINTER
SERVICE CALL ERROR
Explanation
Printer cannot detect paper.
Paper has jammed in the
printer.
Paper ran out or has not
ejected properly.
Paper is not loaded straight.
You tried to print while an error
condition was present.
If the error code is 1133 or
1137, the print head is locked.
If the error code is 3000, a
power cord is not plugged into
the printer properly.
An error has occurred.
Response
Make sure the roll is cut evenly.
Release the paper lever and reload paper. See
page 43 for instructions.
Release the paper lever and remove the
jammed paper. Turn the printer off and then
back on; see page 107 for more information.
Release the paper lever and load paper again.
See page 43 for instructions.
Release the lever and load the paper correctly.
Then return the lever to the Secured position.
Press the P Power button to turn off the
printer. Unplug the printer and wait 30 seconds.
Then plug it in and turn it back on.
Remove the bracket securing the print head;
see page 27.
Press the P Power button to turn off the
printer. Unplug the printer and wait 30 seconds.
Then plug it in securely and turn it back on. If
the message remains, contact Epson as
described on page 11.
Note the error number, then turn the printer
off. Unplug the printer and wait 30 seconds.
Then plug it in and turn it back on. If the
message remains, contact Epson as described
on page 11.
103
Solving Problems | 103