Checking The Print Quality - Epson Stylus Pro GS6000 Setup and Setup And Use Manual

Note: Before printing
without the Auto Take-Up
Reel, be sure to set the
AUTO TAKE-UP REEL
setting to OFF.
Note: If you have any
print quality problems
after cleaning the print
head, see page 74 for
information on additional
print head cleaning cycles
you can run.
It's a good idea to run a
nozzle check and clean
the print head, if
necessary, whenever you
load a new media type or
print a large job. You can
also set the printer to
automatically print a
nozzle check pattern
and/or clean the print
head at set intervals. See
page 114 for details.
9. Set the switch on the top of the reel controller to
10. Set the paper release lever to the
11. When appears on the LCD display, press the
READY
12.
PRINTER SETUP
13. Press d to select
AUTO TAKE-UP REEL
14. Press the Pause button to exit the menus.
Now you can check the print quality as described in the next section.

Checking the Print Quality

When you first set up the printer, it's a good idea to run a nozzle check to
test the print quality.
1. Press the button, press d to highlight
Menu
again.
Menu
2. Select
NOZZLE CHECK
check pattern.
3. Examine the printed pattern to determine if the print head nozzles need
cleaning or not at this point.
Cleaning
not needed
Clean the
print head
Handling Media and Printouts
Secured
is highlighted. Press
, press , and press
Menu
53
.
ON
position.
Menu
again.
Menu
, press , and select
Menu
, and press
TEST PRINT
to print a nozzle
| 53
button.
.
ON