Epson Stylus Pro GS6000 Setup and Setup And Use Manual page 26

26 | Setting Up the Printer
Caution: Make sure the
tip of the cushioning roller
bracket sits between the
rubber stoppers.
Caution: Do not adjust
the third bolt that is
already attached to the
right controller.
6. Hold the cushioning roller as shown and slide the left end onto the post
on the left mounting bracket.
Post
Rubber
stoppers
7. Slide the right end of the cushioning roller bracket onto the post on the
right controller. Rotate the post base to align the holes, then secure the
bracket using two hex bolts.
8. Place the right end of the scroller bar (the end with the metal collar)
down between the rollers in the right controller. Then place the other
end between the white rollers on the left mounting bracket. Make sure
the scroller bar rests between the rollers at each end.
Metal collar
26
Post