18
|
Setting Up the Printer
Note: You also need a
long-handled Phillips-head
screwdriver to assemble
the stand.
Note: You can also
assemble the stand by
placing the legs
upside-down temporarily.
Make sure you tighten all
bolts before moving to
the next section.
Unpacking and Assembling the Stand
1. Unpack the stand and make sure you have all these items.
2 legs
2 bases
2. Insert the right leg into the right base (labeled with an
the hex wrench to fasten the leg with the two bolts.
Front of
stand
Tank
bracket
8 bolts
4 hex screws
18
2 cable
supports
Horizontal strut
8 wing screws
Hex wrench
) as shown. Use
R
Right leg