Adjusting The Paper Feeding Position - Epson Stylus Pro GS6000 Setup and Setup And Use Manual

Adjusting the Paper Feeding Position

If you notice any overlap or white lines in your printed images, you should
adjust the paper feeding position to correct it. You may need to adjust the
feeding position differently for different types of media.
Before adjusting the feeding position, make sure you select the following
control panel settings for your media type:
• Paper Type
• Print Mode
• M/W Adjustment
See page 117 for details on selecting these settings on the
menu. Then follow these steps to adjust the paper feeding position on the
same menu:
1. Press u or d to select
2. Press u or d to select
3. Press u or d to set the feed length to
(recommended), then press
4. Press to print an initial adjustment pattern like this:
5. Cut off the printed pattern to you can more easily measure it. See
page 62 for instructions.
6. Using a ruler with measurements in millimeters, measure the distance
between the two
+
Handling Media and Printouts
PAPER FEED ADJUST
LINE FEED ADJUST
100mm
.
Menu
(plus) signs.
59
PAPER SETUP
, then press .
Menu
, then press .
Menu
, , or
250mm 500mm
| 59