Correct
0.2 inch
(5 mm)
11. Check the position of both edges of the media in relation to the clear
rubber pressure rollers. Each edge should be at least 0.2 inch (5 mm)
away from the edge of the nearest pressure roller, as shown.
Incorrect
Pressure
rollers
If you need to adjust the media's horizontal position, release both roll
holder levers, move the media and holders as necessary, and lock the
levers in place.
12. If you loaded thick media, you may need to adjust the platen gap (head
height) setting. See page 54 for instructions.
Handling Media and Printouts
0.2 inch
(5 mm)
47
|
47