Symantec ALTIRIS DEPLOYMENT SOLUTION 6.9 SP4 - V1.0 Manual page 279

Deployment Solution
To set the TCP port on the Deployment Server
1. From the Deployment Server, click Start > Control Panel > Altiris Deployment
Server > Options > Transport tab.
You can also click Start > All Programs > Altiris > Deployment Solution >
Configuration > Options > Transport tab. This opens the Altiris Deployment
Server transport settings page.
2. Enter the TCP Port number.
3. Click OK.
The following options are available on the Altiris Deployment Server
Communication page:
Use TCP/IP multicasting to find the Altiris Deployment Server: Select this option
to use TCP/IP multicasting to find the Deployment Server. When client computers boot
to automation using this configuration, a multicast packet is broadcast across the
network to find where the Deployment Server is located.
Multicast IP address: Enter a multicast IP address for client computers to
send a broadcast packet across the network to find the Deployment Server.
Port: This option defines which port client computers can use to communicate
with the Deployment Server Engine, which manages the Deployment Database,
sends job commands to the Deployment Agent, and more.
Server name: When you select Use TCP/IP multicasting to find the Altiris
Deployment Server, a multicast packet is broadcast to the server you specify.
If you leave this field blank, the client computer connects to the first server that
responds to the multicast packet.
Use TCP/IP to connect to the Altiris Deployment Server: Select this option to
connect to a specific Deployment Server. You must select this option if your network
adapter or network does not support multicasting. See your network adapter
documentation, call the manufacturer, or consult with your IT department for
information.
Server IP address: Enter the IP address of the Deployment Server to access
information stored in the Deployment Share. If you are using the Intel Universal
NIC driver (UNDI), the IP address is required.
Port: This option defines the port that the client computers can use to
communicate with the Deployment Server Engine, which manages the
Deployment Database, sends job commands to the Deployment Agent, and
more.
Automation Agent Location
Remote: Select this option to run the most recent automation agent located on
the remote server share.
Local: Select this option to run the automation agent that currently exists in
the local pre-boot environment.
Lock Keyboard: Select this option for additional security. This prevents someone on
the remote computer from ending the automation session and possibly accessing your
network.
Introduction to Altiris® Boot Disk Creator
279