Symantec ALTIRIS DEPLOYMENT SOLUTION 6.9 SP4 - V1.0 Manual page 425

RapiDeploy Command-line Switches (Continued)
Switch [parameters]
-p[partition]
-password:[pwd]
-postconfig
-raid:[n]
-raw
-retainstart
-rescan
-restorebt
Deployment Solution
Details
Function Specifies which partition to process.
Parameters
n Number (1-31) uploads the partition (each partition must be
designated separately)
b images the BootWorks partition (works for both hidden and
embedded types)
oem images the oem partition
rs images the recovery partition
Examples
To upload an image of partition 2, type
[filename]
rdeploy -mu -p2 -f
To upload multiple partitions, type
rdeploy -mu -p2 -p3 -p4 -f
To upload the BootWorks partition, type
[filename]
rdeploy -mu -pb -f
To upload the oem partition, type
rdeploy -mu -poem -f
See also -m[mode], -f[path & file name]
Function Specifies the image password. Passwords are case
sensitive.
Example To create a password-protected image file, type
[filename]
rdeploy -mu -f
To restore that file, type
rdeploy -md -f[filename] -password:Altiris
See also -m[mode], -f[path & file name]
Function Perform postconfig from within RDeploy.
Function Specify the software raid level.
Function Treats all partitions as raw. The Master PC reads and
images a partition by sectors rather than by files. This switch
makes the image drive geometry dependent (must have the
same heads, cylinders, and tracks as the image source). Used
mostly by Altiris Technical Support for troubleshooting, or it
could be used to make sure that any extra data residing outside
of the file system is included in the image.
Function Retain the start sector of the first partition. DOS
partitions only, up to 2048 sectors.
Function Reread the partition table after imaging.
Function Restore the boot track during download.
RapiDeploy Technical Reference
[filename]
[filename]
-password:Altiris
425