Installer Return Codes - Symantec ALTIRIS DEPLOYMENT SOLUTION 6.9 SP4 - V1.0 Manual

Error Message
"This image requires that the
destination drive have the
same geometry . . ."
"Error flushing MBR sector."

Installer Return Codes

Deployment Solution
Description
Explanation: The image being transferred contains a
geometry-dependent partition, and the geometry of the
source disk does not match the geometry of the target disk.
This means the disks are not seen as identical drives by the
drive controller.
Explanation: The program was unable to write data to the
first sector on the hard disk. The image transfer is
incomplete because the partition-table and/or master boot
record code was not successfully written, and the disk is in
an indeterminate state.
Possible cause: This may be caused by a BIOS setting that
prevents programmatic access to the boot sector (see the
CMOS setup).
The Deployment Solution Installer returns error codes whenever it encounters any
problems while installing. These return codes are saved in a log file, which is used to
help understand the installation problems. Below is a list of error codes returned with
their descriptions for different components of the Deployment Server.
Return ErrorID
Code
1000 IDS_ERR_SETUP_INSTALL
1001 IDS_ERR_COPYING_LICEN
SE
1002 IDS_ERR_SETUP_INSTALL
1003 IDS_ERR_GRANT_LOGON
Error Description
This return code is for the DataStore
component. This error occurs while
setting up the installation on a remote
computer. This signifies an error in
opening the setup INI file.
This return code is for the DataStore
component. This error occurs while
copying the license file to the remote
computer. Please ensure that the temp
directory on the remote computer has
at least 100MB free space.
This return code is for the Deployment
Server component. This error occurs
while setting up the installation on a
remote computer. This signifies an error
opening the setup INI file.
This return code is for the Deployment
Server component.This error occurs
when it is unable to grant logon as
service rights to the Deployment Server
Service user. If you continue the
installation, it will install the service, but
will require you to manually set "Logon
as Service" rights for the Deployment
Server Service user.
Error Codes
451