Settings Related To Power On/Off; Method Of Turning The Scanner On/Off [Power Sw Control] - Fujitsu 6240 - fi - Document Scanner Operator's Manual

Chapter 9 Operational Settings

9.8 Settings Related to Power ON/OFF

Method of Turning the Scanner ON/OFF
[Power SW Control]
The method by which the scanner is powered on/off can be
specified from one of the following:
Press the [Power] button on the operator panel
Unplug the power cable then plug it back in
Have the scanner turn on/off in sync with the computer's power
1
Start up the Software Operation Panel.
Refer to "9.1 Starting Up the Software Operation Panel" (page
2
From the listing on the left, select [Device Setting 2]
[Power SW Control].
3
Select one of the following:
[Enable power switch] : Press the [Power] button on the operator
[Disable power switch] : Unplug the power cable then plug it back
[Enable USB power
feeding]
Some types of computers and USB hubs keep supplying
power to the USB bus even after the computer is turned
off.
153).
In that case, the [Enable USB power feeding] mode may
not work properly.
panel.
in.
: Have the scanner turn ON/OFF in sync
with the computer's power.
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
188