Chapter 9 Operational Settings
Item
Page Counter
Check the counters to determine when to replace
(page 166)
the consumables.
Also use it to reset the counters after replacing the
consumables.
Power saving
Specify the waiting time before entering power
(page 187)
saving mode.
Offset Setting
Adjust the position to start the scan on the selected
(page 169)
scanning side(s).
Vertical magnification
Adjust the magnification level in feed direction for
Adjustment
the selected scanning method.
(page 169)
*1: Displayed when using the fi-6230Z or fi-6240Z.
*2: Displayed when the imprinter is installed.
Description
Total Page Count(ADF) / Total Page Count(FB) (*1)
/ Brake Roller / Pick Roller
Remaining Ink
Range: 5 to 235 min. (in increments of 5)
Unit: Flat bed (*1) / ADF(front) / ADF(back)
Main/Sub: -2 to +2 mm (in increments of 0.5)
Unit: Flat bed (*1) / ADF
Range: -3.1 to 3.1% (in increments of 0.1)
Parameter/Value
TOP
Contents
Factory Default
Index
0
Introduction
(*2)
Scanner
Overview
15 min.
How to Load
Main/Sub: 0 mm
Documents
Configuring the
0%
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
161