Fujitsu 6240 - fi - Document Scanner Operator's Manual page 113

Chapter 6 Daily Care
Brake roller (×2)
Remove the roller from the scanner.
For details about removing the brake roller, refer to
Brake Roller" (page 119).
Gently wipe along the grooves, taking care not to damage the roller
surface.
Pick roller (×2)
Gently wipe along the grooves as you rotate the roller manually, taking
care not to damage the roller surface. Make sure that it is cleaned
properly because residue on the roller will affect the feeding
performance.
Idler roller (×4)
Gently wipe the surface of the rollers. Make sure that it is cleaned
properly because residue on the roller will affect the feeding
performance. Also be careful not to damage the sponge which is
attached on each roller.
Glass (×2)
Gently wipe the dirt and dust off the surface of the glass sections.
Vertical streaks may appear on the scanned image when the
glass is dirty.
Ultrasonic sensor (×2)
Gently wipe the dirt and dust off the surface of the ultrasonic sensors.
"7.2 Replacing the
Feed roller (×2) / Eject roller (×2)
The power must be turned on to rotate the feed/eject rollers.
1 Turn on the scanner.
For details, refer to
2 Open the ADF when "1" is displayed on the Function Number
Display.
For details, refer to
If it is difficult to clean, use a cotton swab.
Ultrasonic sensor
"1.3 Turning the Power ON/OFF" (page
"1.4 Opening/Closing the ADF" (page
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
23).
Operational
Settings
24).
Appendix
Glossary
113