Fujitsu 6240 - fi - Document Scanner Operator's Manual page 170

Chapter 9 Operational Settings
3
Adjust the level of offset/vertical magnification as needed.
Offset Setting
Unit Select [Flat bed] (*1), [ADF (front)] or
[ADF (back)] as the target for offset adjustment.
Main Adjusts the horizontal (width) offset.
The value can range from -2 to +2 mm (in
increments of 0.5).
Sub Adjusts the vertical (length) offset.
The value can range from -2 to +2 mm (in
increments of 0.5).
Description
Vertical magnification
Adjustment
Unit Select [Flat bed] (*1) or [ADF] as the
target for vertical magnification
adjustment.
Vertical magnification Adjusts the vertical (length)
Adjustment magnification.
(Sub: length) The value can range from -3.1 to
+3.1% (in increments of 0.1).
*1: Displayed when using fi-6230Z or fi-6240Z.
Contents
Description
Introduction
Scanner
Overview
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
TOP
Index
170