Fujitsu 6240 - fi - Document Scanner Operator's Manual page 181

Chapter 9 Operational Settings
3
Select a detection method.
Method
None Does not detect multifeed.
Check Detects multifeed by the overlapping of
Overlapping documents.
(Ultrasonic) When this is selected, you can also specify the
two following options:
Specify the detection range by the length from
the top of the document.
Proceed to
Multifeed [Document check area specification
for Multifeed Detection]" (page 182)
details.
Ignore the multifeed when there is paper of the
same size attached to a designated location
on the page.
Proceed to
Pattern" (page 105)
Check Length Detects multifeed by the difference in length of the
documents.
Note that multifeeds cannot be detected
accurately when scanning a mixed batch of
different sizes.
Description
"Specifying the Area to Detect
for more
"Ignoring Multifeed for a Set
for more details.
Method Description
Check Detects multifeed by the combination of [Check
Overlapping Overlapping (Ultrasonic)] and [Check Length].
and Length Note that multifeeds cannot be detected
accurately when scanning a mixed batch of
different sizes.
When this is selected, you can also specify the
two following options:
Specify the detection range by the length from
the top of the document.
Proceed to "Specifying the Area to Detect
Multifeed [Document check area specification
for Multifeed Detection]" (page 182)
details.
Ignore the multifeed when there is paper of the
same size attached to a designated location
on the page.
Proceed to "Ignoring Multifeed for a Set
Pattern" (page 105)
Length Select a length difference from 10/15/20 mm. Any
length under the specified value will not be
detected as multifeed.
To scan documents with different lengths, specify
[Check Overlapping (Ultrasonic)].
When a photograph or a piece of paper is attached on
the document, the overlapping part of the document
may be falsely detected as multifeed if [Check
Overlapping (Ultrasonic)] is specified. In that case,
specify [Check Length].
Note however that [Check Overlapping (Ultrasonic)]
can still be used by restricting the detection range.
Multifeed cannot be detected when using the Carrier
Sheet.
This setting can also be configured from the scanner
driver's setup dialog box. Note that priority is given to the
scanner driver setting.
Introduction
Scanner
Overview
How to Load
Documents
Configuring the
for more
Scan Settings
How to Use the
Operator Panel
for more details.
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
TOP
Contents
Index
Appendix
Glossary
181