Fujitsu 6240 - fi - Document Scanner Operator's Manual page 129

Chapter 8 Troubleshooting
■Motor circuit error
"H" and "alarm number" are displayed back and forth.
Display Item
H0 Motor circuit error Turn the scanner off then back on.
If the problem persists, write down the
H6 Imprinter system
displayed error code and contact your
malfunction
FUJITSU scanner dealer or an
authorized FUJITSU scanner service
H7 Lamp circuit error
provider.
H8 Motor circuit error
(background
switching
mechanism)
■Option error (when imprinter is installed)
"A" and "alarm number" are displayed back and forth.
Display Item
A0 Imprinter error 1 Confirm that the EXT cable of the
(control board)
A1 Imprinter error
(communication
time-out)
2 Confirm that the print cartridge is
A2 Imprinter error
(print head)
A3 Imprinter error
(EEPROM)
3 Turn the scanner off then back on.
A4 Imprinter error
(ROM)
Resolution
Resolution
imprinter is connected properly to
the EXT connector on the back of
the scanner.
For details, refer to the fi-614PR
Operator's Guide.
installed correctly.
For details, refer to the fi-614PR
Operator's Guide.
If the problem persists, write down
the displayed error code and
contact your FUJITSU scanner
dealer or an authorized FUJITSU
scanner service provider.
■Sensor error
"L" and "alarm number" are displayed back and forth.
Display Item
L6 Sensor error 1 Clear any dust around the
2 Turn the scanner off then back on.
Resolution
ultrasonic sensors.
If the problem persists, write down
the displayed error code and
contact your FUJITSU scanner
dealer or an authorized FUJITSU
scanner service provider.
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
129