Cleaning The Inside; Cleaning The Adf (With Cleaning Paper) - Fujitsu 6240 - fi - Document Scanner Operator's Manual

Chapter 6 Daily Care

6.3 Cleaning the Inside

Cleaning the ADF (with Cleaning Paper)

The ADF can be cleaned with a sheet of Cleaning Paper
moistened with Cleaner F1.
As the scanner continues to feed the documents, paper dust
will accumulate inside the ADF and it may cause scanning
errors.
Cleaning should be performed approximately every 5,000
sheets scanned. Note that this guideline varies depending on
the types of documents you scan. For instance, it may be
necessary to clean the scanner more frequently when you
scan documents on which the toner is not sufficiently fused.
Do not use water or mild detergent to clean the ADF.
It may take a long time to dry if an excessive amount of
Cleaner F1 is used. Use it in small quantity.
1
Turn on the scanner.
For details, refer to "1.3 Turning the Power ON/OFF" (page
2
Spray the Cleaning Paper with Cleaner F1.
3
Pull out the chute extensions according to the length of
the Cleaning Paper.
For details, refer to "1.6 Setting Up the ADF Paper Chute" (page
4
Lift the stacker and stacker extension according to the
length of the Cleaning Paper.
For details, refer to "1.7 Setting Up the Stacker" (page
5
Load the Cleaning Paper in the ADF paper chute.
6
Adjust the side guides to the width of the Cleaning Paper.
Do not leave space between the side guides and the Cleaning Paper.
Otherwise, the Cleaning Paper may be fed skewed.
Side guide
23).
26).
7
Start up an application for scanning and perform a scan.
For details about the scanning procedure in ScandAll PRO, refer to
27).
"ScandAll PRO V2.0 User's Guide".
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
111