Fujitsu 6240 - fi - Document Scanner Operator's Manual page 164

Chapter 9 Operational Settings
Item
Document check area Selected range: Select this item to restrict the area
specification for to run multifeed detection.
Multifeed Detection
Enable / Disable (Middle): Specify whether to enable
(page 182)
or disable multifeed detection in the selected area.
Start (Middle): Specify the start position of the area
in length (mm) from the leading edge of the
document.
End (Middle): Specify the end position of the area in
length (mm) from the leading edge of the document.
Intelligent Multifeed When there is a paper of the same size attached to
Function a designated location on the page, configure the
(page 185) scanner to memorize the location of the attachment
and not detect multifeeds for that location.
Note that you first need to select [Check
Overlapping (Ultrasonic)] or [Check Overlapping
and length] in either the scanner driver's setup
dialog box or the multifeed detection setting in
"Specifying a Multifeed Detection Method
[Multifeed]" (page
Select to clear the overlap pattern (length, location)
memorized in Auto mode.
Specify whether or not to memorize the multifeed
pattern upon power-off.
Number of paper Configure this setting to change the number of
feeding retries feeding retries when a pick error occurs.
(page 175)
Life Counter Alarm Specify the replacement cycle for the consumables.
Setting
(page 168)
Description
180).
Parameter/Value
[Selected range] check box
Enable / Disable
(When [Selected range] is selected)
0 to 510 mm (in increments of 2)
0 to 510 mm (in increments of 2)
Manual mode / Auto mode 1 / Auto mode 2
[Clear overlap pattern] check box
Remember / Do not remember
1 to 12 times
Pick Rollers / Brake Rollers:
10,000 to 2,550,000 sheets
(in increments of 10,000)
TOP
Contents
Factory Default
Index
Not selected
Introduction
Disable Scanner
Overview
0 mm
How to Load
Documents
0 mm
Configuring the
Scan Settings
Manual mode
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Not selected
Do not remember
Replacing the
Consumables
7 times
Troubleshooting
Pick Rollers:
200,000 sheets
Operational
Settings
Brake Rollers:
200,000 sheets
Appendix
Glossary
164